Repairing Your phone if Bricked or Stuck at Samsung Logo

Video Guide:


Repairing Your Phone If you have soft bricked your phone during the installation of nemesis one or any other custom rom or even if doing any stuff with your galaxy y then follow the steps bellow carefully:


Instruction:

- Download package from below download links

- download the required firmware bundle (one of the repacked from the #1 post above)

- install Kies, or Samsung driver pack

{If you have not installed USB Driver for Samsung Galaxy Y Install it from HERE}

- unzip the package, You'll get 3 *.tar (or tar.md5) files

- download Odin3 1.84 or 1.85 from below download links

- stop Kies

- stop all active ADB sessions

- start odin

- do backup of your data and apps

- charge your SGY at least 75%

- remove SGY from USB or charger

- start the device in Download mode

- power off Your SGY

- wait 30 sec

- Press Vol Down, Home, and Power at the same time

- When (about 5 sec) Warning screen appears, release Volume Down and Power, then (a bit later) Home

- press Vol Up (You'll get Odin mode screen)- Browse the 3 tar files to odin PDA=PDA_xxxx.tar, PHONE=MODEM_ or PHONE_xxxxx.tar, CSC=CSC_xxxxx.tar

- no PIT and/or BOOT files required - leave it empty!

- leave all other fields and checkboxes default! Shown in picture below:



- connect your phone, You must see yellow 0:[COMxx] in the first ID:COM and "Added" in the message box

- Start flashing by the START button.

- flashing will start immediately, see the progress in the message box, and progress bar on the phone

- Wait 1-3 minutes, until green PASS! in the upper left

- SGY will reboot, leave it as is for 2-5 minutes until startup finishes

AND NOW YOU ARE DONE!! You have now repaired your phone yourself!